Economical equivalents with quick delivery for replacement of water and wastewater treatment projects.    E-mail: [email protected]

Hollow Fiber Membrane Contactor MCO2-6X44


Hollow Fiber Membrane Contactor MCO2-6X44

Product No.:MCO2-6X44

  • Details

General Information

Hollow fiber membrane contactor is a phase-contacting device containing a hollow fiber membrane for use in gas transfer and liquid-liquid extraction processes.
The working principle of Hollow fiber membrane contactor:
Hollow fiber membrane contactor uses microporous hollow fiber membrane to remove oxygen from water. In a typical operation, water flows outside the membrane hollow fibers, while inside of the hollow fibers are vacuum pumped or gas purged, or both are combined.
The hydrophobically treated hollow fiber membranes have many micro pores on the surface, which allow gas molecules to pass through, but can prevent water molecules from penetrating. Under the negative pressure of vacuum or gas purging, the dissolved gas in the water outside the hollow fiber membrane moves continuously to the inside of the hollow fiber membrane through the micro pores, and is taken away by the vacuum or purging gas, so as to achieve the purpose of removing dissolved oxygen, carbon dioxide and other gases in water or other liquids. Hollow fiber membrane contactor can also be used for membrane extraction, deamination and denitrification etc.


Hollow fiber membrane with bigger surface area
Compact design for normal base construction with installation
Can be installed directly on ground, no need of high position installation.
Works under normal temperature, no need of hot steam for deoxygenation.
Energy consumption comes from vacuum pump and sweep N2
Modular design, can be extended very easily.


Higher flow rate
Energy saving by low energy consumption
High removal efficiency for dissolve oxygen, keep stable at 7 ppb of outlet water.
Small footprint to save CAPEX
Easy to install, operate and maintain for lower OPEX.


Food & beverage
Microelectronics & semiconductors
Gas separation
Inkjet printing
Boiler water
Water and wastewater treatment


Dimensions of Hollow Fiber Membrane Contactor


D (mm/inch)

L (mm/inch)

L1 (mm/inch)

Liquid port

Vacuum port





DN25 union

DN25 union

* More models and customized models are available on request.



Membrane material

Modified PP

Fiber ID/OD

0.22 mm/0.4 mm

Pore size

0.1 μm

Housing material


Membrane area

18 m2


9.9 KG

Processing capacity

0.05 - 1.5 m3/h

Standard removal rate

75% - 95%

Operating Limits



Working temperature

5 - 45℃

DO reachable

< 5 ppb

Max. feed pressure

0.1 MPa (14.5 psi)

Max. Trans-membrane pressure

0.2 MPa (29 psi)

Working pH

3 - 12

Working surface tension

≥ 65 mN/m

1. The hollow fiber membrane contactor is only suitable for deoxidization of clean water, COD < 50 ppm, SS < 5 ppm.
2. Even if COD in water is less than 50 ppm, the surface tension may still be less than 65 mN/m, resulting in membrane infiltration. Therefore, the detection of surface tension is necessary before use.
3. The water should not contain oxidizing substances, such as hypochlorite, hydrogen peroxide, etc. ORP < 100 is required, otherwise the service life of the membrane conctactor will be affected.
4. When used for a long time, the organic and mineral substances in water will cause membrane fouling, which will affect the removal and hydrophobic properties of the membrane. It should be cleaned regularly and restored.

Previous Product:Gas Transfer Membrane MCO2-6X47S

Post your feedback

The Code:

Wechat Code